SPECIFICATIONS
Brand Name: Soufyane
Origin: Mainland China
Voltage: 5V
Battery Life: 30 Hours & Up
Item Size: 8*5.5*2.8cm
Special Feature: Internet Connected
GPS type: GPS Tracker
Model Name: GPS103B 2G/4G
Screen Size: Under 2 Inches
Gps Module: Yes
Out Power: 0.2w
Certification: CE
Certification: FCC
Certification: RoHS
Brand:: Coban
(2G ) Network and Band:: 850/900/1800/1900Mhz
(4G )Network and Band:: 4G LTE: 850/900/1900/2100Mhz; 2G GSM:850/900/1800/1900Mhz
4G LTE frequency:: B1/B2/B3/B4/B5/B7/B8
Communication System:: LTE/GSM 4G/2G SIM card support
Positioning Accuracy:: GPS accuracy: 5-10m; LBS accuracy: 100-1000m
Backup Battery:: Chargeable 3.7V 500mAh 1.85wh Polymer Li-Battery
Special Feature:: With Remote Controller, Remotely Cut Off Engine, Voice Monitor,
Car Power Supply:: 9-40V
Tracking Software:: Life Time Free; iOS & Android APP
Coban 3G Vehicle Tracker GPS Tracker TK103B With Remote Control Cut Off Car Engine Car Gsm Tracking System with ACC Speed Alarm
1. Function Introduction
This tracker is a new product based on theWCDMA/GSM/GPRS network and GPS satellite positioning system, which set multiple functions of security, positioning, monitoring surveillance, emergency alarms and tracking in its entirety. It can track and monitor remote target by SMS or internet.
1.2. Features
1.2.1 Support both GPS & LBS (Location based service).
1.2.2 Support SMS/GPRS/Internet Network data transmission
1.2.3 Support reconnected automatically by the internet of WCDMA/GSM/GPRS
1.2.4 Support SMS / internet(GPRS) dual-mode switching
1.2.5 Support configuration by remote terminal.
1.2.6 Support for point-to-point, point to group, group-to-group monitoring.
1.2.7 Set multiple functions of security, positioning, monitoring surveillance, emergency alarms and tracking in its entirety.
2. Applications
Used widely for vehicle and other moving objects tracking.
Accessories :
Specification:
Content |
specifications |
DIM. |
83*54*26mm |
Weight |
120g |
Network |
WCDMA/GSM/GPRS |
Band |
WCDMA (3G): 850/1900/2100/Mhz |
GSM (2G): 850/900/1800/1900Mhz | |
GPS Sensitivity |
-159dBm |
GPS Accuracy |
5m |
GPS Start time |
Cold status 45s Warm status 35s Hot status 1s |
Voltage |
12 V -24V |
Backup battery |
Chargeable 3.7V 350mAh Polymer Li-Battery |
Storage Temp. |
-40°C to +85°C |
Operation Temp. |
-20°C to +65°C |
Humidity |
5%--95% non-condensing |
Main Functions:
1.Single Locating.
2.Auto track continuously.
3.Turning points update automatically.
4.GPS drift suppression.
5.Exact street address.
6.Location based service (LBS) / Cell-ID Locating.
7.Monitor.gps locator
8.Data logging.
9.Data Load.
10.Forward the third parties’ message.
11.SIM card Balance Inquiry.
12.ACC working alarm.
13.Cut off the Oil and Power System
14.Calibration of fuel sensor
15.Arm.
16.Disarm
17.Silent Mode.
18.Decide how many times of alarm message.
19.Alarms
*Low battery alarm
*Power off alarm
*GPS blind Spot alert
*Geo-fence
*Multi-area management
*Movement alarm
*Over speed alarm
*SOS
*Fuel alarm
20.Alarms under ARM State
*ACC alarm
*Door open alarm
*Built in Acceleration Sensor Alarm
*Built in Shock sensor sensitivity configuration
*Alarm without GSM network service
21.Sleep Mode
22.Check IMEI.
23.Check the Vehicle State.
24.Terminal (local) Time Setting
25.Reset Hardware
26.Configure parameters by USB
27.GPRS Setting
28.Less GPRS traffic.
29.Activate "Fuel" value in GPRS data
Operating Instructions
Terminal Installation
1. Please ask the qualified engineers to install it.
2. Do not install it in an environment which is over WCDMA/GSM performance index, and please pay attention to fix the antennas in an appropriate position with good signals.
3. Pay attention to make installation location preventing water and dust.
4. Find the 10 PIN harness and insert it into the corresponding holes of the products, and connect the wires with the original car circuit showing below:
Note:
1. The orange wire can be connected to the original car horn; it can also be connected to the siren you buy with the tracker. (Siren is Option)
2. Knowing about the type of the door trigger is positive or negative trigger. Please connect the green wire to the door control circuit if it is positive, and connect blue wire if it is negative.
3. Please put SOS button at the place driver can touch.
4. Insert the external shock sensor plug into the sensor jack. (External shock sensor is Option)
5. Insert the external monitor Microphone into the monitor jack.
6. Connect the GPS and WCDMA/GSM antenna to the right connector, and find an appropriate place to fix the antennas to make sure it receives signals well.
SIM CARD Installations
1. Use a tweezers or a sharp thing to touch the SIM CARD popup switch, the SIM CARD slot will pop up, take out the SIM card slot and put SIM card in it. And then put the SIM card slot back to its original position after confirm the SIM card in the right place.
2. Please make sure the SIM card is for WCDMA/GSM network and able to execute the function of incoming calls display, no calls can be diverted and the PIN code is locked. The SMS format must be TXT format, and can’t recognize the PDU format.
Turn on the Tracker Device
Connect the positive and negative wire, red and black ones, with 12V or 24V car power system, wait for 1 minute after connecting power to wait tracker works normal, and then turn on the backup battery switch.
WCDMA/GSM/GPS LED Indicator
LED Indicator Type |
Behavior |
Meaning |
|
Red LED |
ON |
NoWCDMA/GSM signal |
|
Flash quickly, 1 time per second |
SMSmode with good reception |
|
|
Flash slowly, 1 time per 3 seconds |
Internet(GPRS) mode |
|
|
Green LED |
ON |
Fix to satellites |
OFF |
Lost fix to satellites |
FAQ
For best results, use short gentle strokes going from neck to tail avoiding less fur covered areas like the stomach. Carefully adjust pressure based on your pet's tolerance. Be extra careful around bony areas such as hip bones and spine. Always use on a dry coat. Plus you'll get instructions on use delivered with your product.
Not at all! Our PetBrush has been designed with your pet’s comfort in mind. With 51 perfectly sized bristles, the PetBrush massages the skin and coat while removing loose topcoat, dander, dirt, and sand.
Just maneuver the slide back to retract the edges and your pet’s fur, dander, and dirt will come off leaving a clean surface.
The PetBrush was designed with all dog breeds in mind. Due to the adjustable comb, as long as your dog has a fur coat, the PetBrush will be extremely effective. Generally, the longer the coat the more hair the PetBrush® will remove.
Yes, as long as your pet has a coat, the PetBrush will work it's magic and remove loose fur, dirt and undercoat. Be sure to retract the comb suitable to your pets coat.